Parallel Installation
Mounting
IMPORTANT SAFETY INSTRUCTIONS
This component is for indoor use due to its IP44 protection (to achieve better sealing you must close it in a space that guarantees the required IP). IP-65 option is possible on request. Regularly check the cable, transformer and all other components for damage. If any component is damaged, the product should not be used. Important information! Keep these instructions for future reference.
WARNING!
The light source of this product consists of light-emitting diodes (LEDs) that cannot be replaced. Do not disassemble the product; the LEDs may cause eye damage. Do not immerse in water.
Alignment in profile
Measurement
M & XL models (~1 mm)
Model L (~20 mm)
Flex L models (~16 mm)
Fixing
All models
Wiring
Models M, L and XL
We recommend the use of a professional tool to open the connector.
If not available, use the tip of a BIC type ballpoint pen.
Feed from larger to smaller.
Model Flex L - Flexible connector
1 – Use the flexible tape for the connection between the luminaires and with the Filter Flex adapter. Exceptionally, if any flexible tape is missing, we recommend connecting the elements with AWG 18-22 flexible cable to the additional connectors.
2 – Connect the positive and negative wires of the source as shown in the picture to the adapter.
If the Filter Flex converter is not available, we recommend connecting the source via the additional connectors.
Cut
Models M, and XL
Welding
M models only
Dimming
Standard models 24V
MODELS M & XL ONLY
Parallel L is not compatible with dimming, as an alternative you must use Parallel Flex L.
CC models (High efficiency)
We recommend using Actilum high efficiency DC power supplies.
Dimming - Parallel Flex L only
Dimming scheme for stretch ceilings (only CC products)
DIMMING 1 CHANNEL
DYNAMIC WHITE DIMMING
